1981-1982 Shovelhead Wings Gray & Silver
This is a complete set of gas tank reproduction decals for
- 1981 Harley-Davidson FLH-80 Electra-Glide
- 1981 Harley-Davidson FLT Tour Glide
- 1981 Harley-Davidson FLT Tour Glide Classic
- 1982 Harley-Davidson FLH-80 Electra-Glide
- 1982 Harley-Davidson FLT Tour Glide
Will also fit almost any H-D or chopper tank:
- big twin splits (shovels, pans, dyna’s, softails’s, ..)
- superglide “bread loafs”
- 2.3 gal sportster peanuts
- 3.2 gal sportster kings
You’ll receive two wings. A left side and a right side.
€100.00
Every decal in this store is made to order from our workshop in Charleroi, Belgium.
Orders are dispatched twice a week and usually reach Europe and North America within around 10 days, and the rest of the world in 10–30 days. Registered Mail is free for orders over €150 / $150.
Every decal is redrawn from NOS / deadstock originals, so shapes, proportions and colors stay as close as possible to the factory artwork.
They’re printed on 3M-like cast vinyl using heritage American-made machinery, with small-batch production to keep quality consistent.
- f your kit comes as a combined sheet, cut it so each decal is on its own piece.
- Mock up the decals on the tank using masking tape and measure to confirm the correct placement.
- Degrease the tank thoroughly.
- Remove the backing paper from the first decal and place it on the tank.
- Using a soft squeegee, chase any trapped air bubbles from the center out to the edges while the application tape is still on.
- Peel off the application tape.
- Repeat steps 4–6, one decal at a time, until the kit is fully installed.
Please refer to the specs table to see:
- whether clear water (wet application) is recommended for this decal set,
- whether the decals can or must be clearcoated.
Caution: acrylic lacquers only.
Parts for Harley-Davidson® Motorcycles.
Reproduction decals 100% redrawn and produced in Belgium.
