1975 FLH Electra Glide Rainbow

Thickness:70 microns (2.76 mil)
Water Application:Not Recommended
Clearcoat Over:Recommended
Replica of Harley-Davidson® Part Number(s):
1 x61150-75Upper Right
1 x61257-75Lower Right
1 x61153-75Upper Left
1 x61259-75Lower Left



This is a complete set of gas tank reproduction decals for

  • 1975 AMF|Harley-Davidson Shovelhead FLH-1200 Electra Glide

Additional information

Weight100 g

Rust is Gold Co.

Every single product listed on this store is in stock and ready to ship from our workshop in Belgium.

Registered Mail shipments ship twice a week and are usually delivered within 10 days in Europe and North America, 10-30 days anywhere else. Free for orders over 130$!

UPS Express shipments are picked up every weekday and are usually delivered within 2 days in North America, 4-5 days anywhere else.

Every possible care has been taken to make them look like they just left the factory.

  • They're carefully redrawn from NOS decals. It guarantees an accurate reproduction with regard to shape, size and color.
  • 3M-like vinyl has been used just like it was done by AMF back in the days.

  1. Cut each block of decal if your design comes as a combined sheet.
  2. Mock them up using masking tape. Measure the correct placement.
  3. Degrease the tank.
  4. Remove the backing paper off the first decal and place it.
  5. Chase the trapped air bubbles using a soft squeegee. Work from the center to the edges. Do it while the application tape is still on!
  6. Peal off the the application tape.
  7. Go back to #4 one decal at a time, repeat
  8. You’re done!

Please refer to the specs table if the use of clear water during application is recommended or not.

Please refer to the specs table if the decals can or have to be clearcoated over. Caution: acrylic lacquers only!

Parts for Harley-Davidson® Motorcycles.
Reproduction decals 100% redrawn and produced in Belgium.