1958-1960 Sportster

This is a complete set of gas tank reproduction decals for:

  • 1958 to 1960 Harley-Davidson Ironhead Sportsters (KH, XL, XLH, XLCH)

You’ll receive two logo’s for a complete tank (both sides). The left side decal is mirrored which means the checkered V faces the front of the tank.

This set is made of 3M metallic vinyl. The original decals were the water slide type back in the days.

MPN: 58XLMAIN
Features:Silver Metallic, Gold Metallic
Thickness:70 microns (2.76 mil)
Water Application:Recommended
Clearcoat Over:Mandatory
Replica of Harley-Davidson® Part Number(s):
1 x61780-58Right Side
1 x61781-58Left Side

50,00

Description

This is a complete set of gas tank reproduction decals for:

  • 1958 to 1960 Harley-Davidson Ironhead Sportsters (KH, XL, XLH, XLCH)

You’ll receive two logo’s for a complete tank (both sides). The left side decal is mirrored which means the checkered V faces the front of the tank.

This set is made of 3M metallic vinyl. The original decals were the water slide type back in the days.

Additional information

Weight100 g
Brand

Rust is Gold Co.

Every single product listed on this store is in stock and ready to ship from our workshop in Belgium.

Registered Mail shipments ship twice a week and are usually delivered within 10 days in Europe and North America, 10-30 days anywhere else. Free for orders over 130$!

UPS Express shipments are picked up every weekday and are usually delivered within 2 days in North America, 4-5 days anywhere else.

Every possible care has been taken to make them look like they just left the factory.

  • They're carefully redrawn from NOS decals. It guarantees an accurate reproduction with regard to shape, size and color.
  • 3M-like vinyl has been used just like it was done by AMF back in the days.

  1. Cut each block of decal if your design comes as a combined sheet.
  2. Mock them up using masking tape. Measure the correct placement.
  3. Degrease the tank.
  4. Remove the backing paper off the first decal and place it.
  5. Chase the trapped air bubbles using a soft squeegee. Work from the center to the edges. Do it while the application tape is still on!
  6. Peal off the the application tape.
  7. Go back to #4 one decal at a time, repeat
  8. You’re done!

Please refer to the specs table if the use of clear water during application is recommended or not.

Please refer to the specs table if the decals can or have to be clearcoated over. Caution: acrylic lacquers only!

Parts for Harley-Davidson® Motorcycles.
Reproduction decals 100% redrawn and produced in Belgium.