1972 to 1975 Fender Trim Tape

This is a set of fender reproduction decals for
1972, 1973, 1974, 1975 AMF|Harley-Davidson Ironhead Sportsters
1972, 1973, 1974, 1975 AMF|Harley-Davidson Shovelhead FX

You’ll receive two rolls of 1 meter each. That’s enough to make the front and the rear fender.

It is not a fluorescent orange tape. It’s a regular red.

Availability:In Stock
MPN: 72XLTAPE
Thickness:70 microns (2.76 mil)
Water Application:Recommended
Clearcoat Over:Mandatory
Replica of Harley-Davidson® Part Number(s):
1 x59208-72 or 59208-74Trim Tape, Front Fender
1 x59650-72 or 59650-74Trim Tape, Rear Fender

50,00

Description

This is a set of fender reproduction decals for
1972, 1973, 1974, 1975 AMF|Harley-Davidson Ironhead Sportsters
1972, 1973, 1974, 1975 AMF|Harley-Davidson Shovelhead FX

You’ll receive two rolls of 1 meter each. That’s enough to make the front and the rear fender.

It is not a fluorescent orange tape. It’s a regular red.

Additional information

Weight100 g
Brand

Rust is Gold Co.

Every single product listed on this store is in stock and ready to ship from our workshop in Belgium.

Registered Mail shipments ship twice a week and are usually delivered within 10 days in Europe and North America, 10-30 days anywhere else. Free for orders over 130$!

UPS Express shipments are picked up every weekday and are usually delivered within 2 days in North America, 4-5 days anywhere else.

Every possible care has been taken to make them look like they just left the factory.

  • They're carefully redrawn from NOS decals. It guarantees an accurate reproduction with regard to shape, size and color.
  • 3M-like vinyl has been used just like it was done by AMF back in the days.

  1. Cut each block of decal if your design comes as a combined sheet.
  2. Mock them up using masking tape. Measure the correct placement.
  3. Degrease the tank.
  4. Remove the backing paper off the first decal and place it.
  5. Chase the trapped air bubbles using a soft squeegee. Work from the center to the edges. Do it while the application tape is still on!
  6. Peal off the the application tape.
  7. Go back to #4 one decal at a time, repeat
  8. You’re done!

Please refer to the specs table if the use of clear water during application is recommended or not.

Please refer to the specs table if the decals can or have to be clearcoated over. Caution: acrylic lacquers only!

Parts for Harley-Davidson® Motorcycles.
Reproduction decals 100% redrawn and produced in Belgium.