1986 FXRD WINDSHIELD BLUE & SILVER
This is a windshield reproduction decal for
- 1986 Harley-Davidson FXRD Sport Glide Grand Touring
It’s perfect down to the half-tone patterns. Comes die cut.
It applies to the outside of the windshield. Not between the windshield and fairing.
It ships rolled in a box. When you receive it please lay it on a table and let it flatten up overnight under a few heavy books.
The use of water and PH-neutral soap during application is highly recommended. Let it dry and bond for a couple of days before you take your FXRD for a drive.
€140.00
Description
This is a windshield reproduction decal for
- 1986 Harley-Davidson FXRD Sport Glide Grand Touring
It’s perfect down to the half-tone patterns. Comes die cut.
It applies to the outside of the windshield. Not between the windshield and fairing.
It ships rolled in a box. When you receive it please lay it on a table and let it flatten up overnight under a few heavy books.
The use of water and PH-neutral soap during application is highly recommended. Let it dry and bond for a couple of days before you take your FXRD for a drive.
Every decal in this store is made to order from our workshop in Charleroi, Belgium.
Orders are dispatched twice a week and usually reach Europe and North America within around 10 days, and the rest of the world in 10–30 days. Registered Mail is free for orders over €150 / $150.
Every decal is redrawn from NOS / deadstock originals, so shapes, proportions and colors stay as close as possible to the factory artwork.
They’re printed on 3M-like cast vinyl using heritage American-made machinery, with small-batch production to keep quality consistent.
- f your kit comes as a combined sheet, cut it so each decal is on its own piece.
- Mock up the decals on the tank using masking tape and measure to confirm the correct placement.
- Degrease the tank thoroughly.
- Remove the backing paper from the first decal and place it on the tank.
- Using a soft squeegee, chase any trapped air bubbles from the center out to the edges while the application tape is still on.
- Peel off the application tape.
- Repeat steps 4–6, one decal at a time, until the kit is fully installed.
Please refer to the specs table to see:
- whether clear water (wet application) is recommended for this decal set,
- whether the decals can or must be clearcoated.
Caution: acrylic lacquers only.
Parts for Harley-Davidson® Motorcycles.
Reproduction decals 100% redrawn and produced in Belgium.
